- Thank you for formally accepting my answer*
NARX model training in the Neural Network Tool Box
3 次查看(过去 30 天)
显示 更早的评论
I have Two questions concerning NARX neural network model when training is done using the early stopping technique:
- It is true that NARX model is trained with a static configuration?
- If yes, which one of the errors is used to stop training : error (between actual data/predicted data) calculated using a feed back or without feed back like the classic MLP static network? (please see figure below)
Thank your in advance for your response.
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/150326/image.jpeg)
0 个评论
采纳的回答
Greg Heath
2013-10-7
编辑:Greg Heath
2013-10-7
Narnet and narxnet have two modes: OPENLOOP and CLOSELOOP.
The training of these and most of the MATLAB NNs is stopped via te FIRST of 6 conditions. For example,
net = narxnet % NO SEMICOLON
TrainParams = net.trainParam % NO SEMICOLON
% Partial results
trainParam: .showWindow, .showCommandLine, .show, .epochs,
.time, .goal, .min_grad, .max_fail, .mu, .mu_dec,
.mu_inc, .mu_max
TrainParams =
Function Parameters for 'trainlm'
Maximum Epochs epochs: 1000
Maximum Training Time time: Inf
Performance Goal goal: 0
Minimum Gradient min_grad: 1e-005
Maximum Validation Checks max_fail: 6
Maximum mu mu_max: 10000000000
The OPENLOOP mode is static and only used for training with target data fed into the feedback delay nodes. However, when it is converted to CLOSELOOP for operational use, the accuracy can be worse than if it had been directly trained in the CLOSELOOP mode.
The CLOSELOOP configuration is dynamic and is used for both training and use in the operational mode. However, CLOSELOOP training is very slow compared to OPENLOOP training and the final results may not match well with the target data.
Therefore, there are three approaches to training an operational CLOSELOOP net.
1. Train and operate CLOSELOOP
2. Train OPENLOOP and convert to CLOSELOOP for operational use
3. Train OPENLOOP, convert to CLOSELOOP to train further and use for operation.
The third method tends to yield the best results.
Hope this helps
Greg
0 个评论
更多回答(2 个)
Greg Heath
2013-10-8
See the examples in
help preparets
help closeloop
Also see if the doc explanations and examples are different.
Hope this helps.
Thank you for formally accepting my answer
Greg
P.S. Change names when converting to the closeloop configuration
netc = closeloop(net);
4 个评论
Greg Heath
2013-10-13
OK. Now try it.
I always compare the close-loop and open-loop responses before close-loop training to get an appreciation for what the additional training really did.
And sometimes I train close-loop from the beginning to see how much pre-training with open-loop really helps w.r.t. training time.
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Modeling and Prediction with NARX and Time-Delay Networks 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!