Doubts regarding the SimRF blockset of Simulink

1 次查看（过去 30 天）
Mahitha
Mahitha 2013-10-23
评论： Mahitha 2013-10-24
Hi All,
I have two doubts regarding the SimRF toobox as listed below:
1.When I use the filter from Idealized baseband part of toolbox and provide the desired parameters,say I used LPF,I do not see any filtering action happening. That is,if the input to the filter has 3 frequencies(20,80,120 Hz) and the filter cutoff is 20 Hz, the output of the filter has lower magnitude signal, but all the frequencies are still present. So the question is will the filter do convolution also or will it just provide filter coefficients?
2.If I use the continuous wave source(CW),the time scope output looks like a DC,that is I can only see the amplitude and not the frequency.Also I want to know how to view the output of CW using a spectrum scope.
Please help me solve these immediately. Thanks in advance!

请先登录，再回答此问题。

回答（1 个）

Mark
Mark 2013-10-23
Thanks for the questions.
1. It's hard to answer this without seeing the model. Please contact tech support at MathWorks to show them the model you're trying to run. http://www.mathworks.com/support/contact_us/
2. The CW source of the Circuit Envelope library produces a constant modulation on top of the carrier frequency specified in the source. A flat "DC" response is exactly how a constant modulation looks. To see the real passband shape of the CW source waveform, pass its output through a SimRF Outport and in the Outport choose the "Real passband" option.
Best wishes,
Mark
  1 个评论
Mahitha
Mahitha 2013-10-24
Thank you Mark.
Where do I choose the "Real Passband" option in SimRF outport? When I check the Block parameters of SimRF outport, I can only change Sensor type, Output and Carrier frequencies.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Circuit Envelope Simulation 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by