Counter that starts on demand

1 次查看（过去 30 天）

cyberdyne 2011-6-15

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/9592-counter-that-starts-on-demand

Hi,

How can I build a counter that starts to count from 0 only after a specific start signal and stops after an other signal (by simulink) ?

回答（1 个）

Kaustubha Govind 2011-6-16

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/9592-counter-that-starts-on-demand#answer_13238

Perhaps you could use the Counter Free-Running block inside an Enabled Subsystem and construct the enable signals based on your other two signals?

2 个评论
显示无隐藏无

cyberdyne 2011-6-16

But in this way it counts as simulation time and returns the final count when it is enable, is it? I need that it starts at enable signal.

Kaustubha Govind 2011-6-16

Are you saying that the subsystem starts executing at the beginning of simulation? No - it depends on whenever the enable signals goes active. So you can construct your enable signal such that the counter only executes for the duration that you want it to.

请先登录，再进行评论。

请先登录，再回答此问题。