Setup for Tuning Simulink Models

Configure Simulink^® models for command-line tuning

To tune a Simulink model at the command-line, use the slTuner interface to configure the model for tuning, specify blocks to tune, and specify analysis points. The slTuner interface stores a linear approximation of the Simulink model and other information required to tune the system. For an example, see Create and Configure slTuner Interface to Simulink Model. (Tuning Simulink models requires Simulink Control Design™ software.)

Functions

expand all

Create slTuner Interface

`slTuner`	Interface for control system tuning of Simulink models
`slTunerOptions`	Set `slTuner` interface options

Modify slTuner Interface

`addBlock`	Add block to list of tuned blocks for `slTuner` interface
`addOpening`	Add signal to list of openings for `slLinearizer` or `slTuner` interface
`addPoint`	Add signal to list of analysis points for `slLinearizer` or `slTuner` interface
`refresh`	Resynchronize `slLinearizer` or `slTuner` interface with current model state
`removeAllOpenings`	Remove all openings from list of permanent openings in `slLinearizer` or `slTuner` interface
`removeAllPoints`	Remove all points from list of analysis points in `slLinearizer` or `slTuner` interface
`removeBlock`	Remove block from list of tuned blocks in `slTuner` interface
`removeOpening`	Remove opening from list of permanent loop openings in `slLinearizer` or `slTuner` interface
`removePoint`	Remove point from list of analysis points in `slLinearizer` or `slTuner` interface
`setBlockParam`	Set parameterization of tuned block in `slTuner` interface
`setBlockRateConversion`	Set rate conversion settings for tuned block in `slTuner` interface
`setBlockValue`	Set value of tuned block parameterization in `slTuner` interface
`writeBlockValue`	Update block values in Simulink model
`writeLookupTableData`	Update portion of tuned lookup table

Query slTuner Interface

`getBlockParam`	Get parameterization of tuned block in `slTuner` interface
`getBlockRateConversion`	Get rate conversion settings for tuned block in `slTuner` interface
`getBlockValue`	Get current value of tuned block parameterization in `slTuner` interface
`getOpenings`	Get list of openings for `slLinearizer` or `slTuner` interface
`getPoints`	Get list of analysis points for `slLinearizer` or `slTuner` interface
`showTunable`	Show value of parameterizations of tunable blocks of `slTuner` interface

Topics

Create and Configure slTuner Interface to Simulink Model
Use slTuner to create an interface to a Simulink model for command-line control system tuning and analysis.
Tune Control Systems in Simulink
At the command line, use systune or looptune to automatically tune control systems modeled in Simulink.
Mark Signals of Interest for Control System Analysis and Design
Analysis points allow you to access to internal signals, perform open-loop analysis, or specify requirements for controller tuning in systems modeled in either MATLAB^® or Simulink.
How Tuned Simulink Blocks Are Parameterized
Both Control System Tuner and the slTuner interface automatically assign predefined parameterizations to certain Simulink blocks.