部署
如何部署 Simulink® 模型并与连接到开发计算机的 AMD® SoC 平台进行交互。
模型设置
主题
- Set Up AMD SoC Devices and Software
Install AMD SoC device software and set up the hardware.
- Build and Run Executable on AMD SoC Devices
Build and run executable on AMD SoC devices.
- Stop or Restart Executable Running on AMD SoC Devices
Stop or restart an executable running on AMD Zynq board.
- 具有外部模式仿真的主机-目标通信
通过开发计算机和目标硬件之间的通信通道调整参数和监控信号。
- 使用 XCP 通信进行外部模式仿真
运行使用 XCP 通信通道的外部模式仿真。
- 使用 TCP/IP 的外部模式仿真
运行使用 TCP/IP 或串行通信通道的外部模式仿真。
疑难解答
Get IP Address of AMD SoC Device
You can get the IP address of the AMD SoC device from the MATLAB® Command Window or using the Linux® command line.
Command Line Session with AMD SoC Devices
Open a serial command-line session with AMD SoC devices.
精选示例
Parameter Tuning with External Mode Simulation
Run a Simulink® model in external mode on an ARM® Cortex®-A processor on an AMD Zynq® board.
Communicate with the Programmable Logic IP Core on AMD Zynq Board by Using AXI4-Lite Protocol
Communicate with the programmable logic IP core on an AMD Zynq® board by using the Advanced eXtensible Interface 4 Lite (AXI4®-Lite) protocol.
Basic Control Algorithm Partitioned into FPGA and ARM
Models a field-oriented controller (FOC) for a permanent magnet synchronous machine (PMSM) on the AMD Zynq® UltraScale+™ MPSoC target. This example uses the Trenz Electronic™ Motor Control Development Kit TE0820 revision 4. If you do not have the required hardware, you can use this example to help you develop a controller for your own hardware configuration.
Deploy Standalone Application to Zynq Board for Run on Startup
Manually deploy the ARM software executable that you generate from a Simulink® model to your Zynq board (for example, Zedboard, ZC702, ZC706, ZCU102, or others). After manual deployment, you can run the executable without a connection to Simulink on your development computer.
