Main Content

Annular Orifice

(To be removed) Hydraulic variable orifice created by circular tube and round insert

expand all in page

The Hydraulics (Isothermal) library will be removed in a future release. Use the Isothermal Liquid library instead. (since R2020a)

For more information on updating your models, see Upgrading Hydraulic Models to Use Isothermal Liquid Blocks.

  • Annular Orifice block

Libraries:
Simscape / Fluids / Hydraulics (Isothermal) / Orifices

Description

The Annular Orifice block annular leakage in a fully-developed laminar flow created by a circular tube and a round insert in an isothermal liquid network. The insert can be located off-center from the tube by an eccentricity value.

The flow rate is computed using the Hagen-Poiseuille equation (see [1]):

q=πR(R−r)36νρL·(1+32ε2)·p

ε=eR−r

where

qFlow rate
pPressure differential
ROrifice radius
rInsert radius
LOverlap length
εEccentricity ratio
eEccentricity
ρFluid density
νFluid kinematic viscosity

Use this block to simulate leakage path in plungers, valves, and cylinders.

The block positive direction is from port A to port B. This means that the flow rate is positive if it flows from A to B and the pressure differential is determined as Δp=pA−pB,. Positive signal at the physical signal port S increases or decreases the overlap, depending on the value of the parameter Orifice orientation.

Assumptions and Limitations

Fluid inertia is not taken into account.

Ports

Input

expand all

Physical signal port that controls the insert displacement.

Conserving

expand all

Hydraulic conserving port associated with the orifice inlet.

Hydraulic conserving port associated with the orifice outlet.

Parameters

expand all

The radius of the tube.

The radius of the insert.

The distance between the central axes of the insert and the tube. The parameter can be a positive value, smaller than the difference between the radius of the tube and the radius of the insert, or equal to zero for coaxial configuration.

Initial overlap between the tube and the insert. The parameter must be positive. The value of the initial length does not depend on the orifice orientation.

Specifies the effect of the control signal on the orifice overlap.

References

[1] Noah D. Manring, Hydraulic Control Systems, John Wiley & Sons, 2005

Extended Capabilities

C/C++ Code Generation
Generate C and C++ code using Simulink® Coder™.

Version History

Introduced in R2006b

collapse all

R2023a: To be removed

The Hydraulics (Isothermal) library will be removed in a future release. Use the Isothermal Liquid library instead.

For more information on updating your models, see Upgrading Hydraulic Models to Use Isothermal Liquid Blocks.

See Also

| | | | |