Get Started with Wireless Testbench

Wireless Testbench™ enables you to test wideband wireless systems and perform spectrum monitoring with high-speed data capture using MATLAB^® with USRP™ N3xx, X3xx, or X4xx.

You can set waveform-specific characteristics in hardware to trigger the capture of data of interest for post-processing and analysis in MATLAB. You can use hardware-based resampling to transmit and capture custom signals at arbitrary sample rates or standards-based signals (5G and WLAN) at their native sample rates. You can also integrate custom IP blocks with RF Network-on-Chip (RFNoC™) into the signal processing chain on the USRP FPGA (with HDL Coder™).

Tutorials

• Capture from Frequency Band
  

  Capture IQ data using single radio antenna and plot the frequency spectrum of the captured data.

• Triggered Capture Using Preamble Detection
  

  Capture data from the air upon detecting a preamble sequence.

• Triggered Capture Using Energy Detection
  

  Capture data from the air upon detecting signal energy.

• Transmit Waveform
  

  Transmit generated waveform using single radio antenna.

• Loopback Transmit and Capture
  

  Transmit and capture generated waveform using single radio.

About SDR Design

• Wireless Testbench Applications on NI USRP Radios
  

  Learn how Wireless Testbench integrates NI™ USRP radio capabilities.

• HDL Code Generation for NI USRP Radios
  

  Learn about Wireless Testbench workflows for deploying custom algorithms on NI USRP radios.

• Supported Radio Devices
  

  Determine which NI USRP radios you can use with Wireless Testbench.