Dynamic Transfer Function in simulink

4 次查看（过去 30 天）
Javier Gonzalez
Javier Gonzalez 2011-6-27
评论： Shahzad Ali 2018-7-2
I have a Transfer function of my model... but my model is dynamic, the coefficients change in time . so this means that i need to represent this in Simulink, but i haven't being able to represent this , the blocks of TF in simulink are for fixed values. Any ideas???
b3*s^3+b2*s^2+b1*s^1+b0
-------------------------------------
a5*s^5+a4*s^4+a3*s^3+a2*s^2+a1*s+a0

请先登录，再回答此问题。

采纳的回答

Guy Rouleau
Guy Rouleau 2011-6-27
I recommend this solution "How do I model a transfer function with coefficients that vary with simulation time in Simulink 7.5 (R2010a)?"
http://www.mathworks.com/support/solutions/en/data/1-D9A379/?solution=1-D9A379
I also recommend going through this post on this exact topic:
http://blogs.mathworks.com/seth/2011/03/08/how-do-i-change-a-block-parameter-based-on-the-output-of-another-block/

更多回答（3 个）

Fangjun Jiang
Fangjun Jiang 2011-6-27
No. When you use the transfer function block in Simulink, you can specify the coefficients as b1, b2, a1, a2, etc. Then you'll have to set the value for a1, a2, b1, b2 etc. in the MATLAB base workspace. Then you can change the value for a1, a2, b1, b2 and re-run simulation without changing your Simulink model.
  2 个评论
Paulo Silva
Paulo Silva 2011-6-27
Actually it's possible to change the parameters with time without stopping the simulation, the only thing that can't change is the size of the Numerator and Denominator of the transfer function.
Shahzad Ali
Shahzad Ali 2018-7-2
can you please tell me that how to change the coefficients of the transfer function without stopping the simulation. it would be very helpful. i have a complex system but i ask this question for a simple block, which i am going to link it for you. https://ch.mathworks.com/matlabcentral/answers/408336-how-to-change-the-coefficients-of-a-transfer-function-block-in-simulink-during-simulation?s_tid=prof_contriblnk

请先登录，再进行评论。

Javier Gonzalez
Javier Gonzalez 2011-6-27
Well... what I need is in the same simulation without stop change the values of the a1, b1.... and change this again, i know how to change this but how to represent this is the key.. i have seen something about Observability, in control theory.. but is not clear for me...
Fangjun Jiang
Fangjun Jiang 2011-6-27
Okay, then you need to do the controller realization of the transfer function. Refer to this article but do a double check with a creditable control theory text book. In stead of constant block, you can use a dynamic signal to implement the multiplication so a1, b1 etc. can be changed during the simulation.

类别

在 Help Center 和 File Exchange 中查找有关 Simulink 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by