How can i set block parameters from m-file?
显示 更早的评论
Hi,
I´m using simulink dsp toolbox in order to record and reproduce audio and i need to let the user of my future program, to be able to select the Device to record/reproduce from a GUI.
Therefore it has to be handled from an m-file.
I tried the following without success:
My intention here was to see were the value was stored in order to change it later.
- ParameterValue = get_param('Model/Subsystem/From Audio Device','DialogParameters')
- ParameterValue = get_param('Model/Subsystem/From Audio Device','ObjectParameters')
Both commands result in a structure with multiple parameters but i could not find where the value of the currently selected sound card is.
I need to be able to set "From Audio Device" and "To Audio Device" Device name according to the available sound cards installed. Ideas?
Thanks in advance!
PD: I need to use simulink blocks, so no dsp.audiorecorder, or DAQ to stream audio.
采纳的回答
Puneet Rana
2013-11-12
Hello Sergio,
'DeviceName' is the property of the 'To Audio Device' and 'From Audio Device' that contains the currently selected audio device in that block. You can access it using:
>> get_param('Model/From Audio Device', 'DeviceName')
ans =
Default
>> get_param('Model/To Audio Device', 'DeviceName')
ans =
Default
and similarly set the property using set_param.
Another tip: Since you mentioned that you will be using a GUI where the user can select an audio device from a list, it may be a good idea to populate that list using 'dspAudioDeviceInfo' function. This function returns a list of all audio devices on the current computer, it would be the same as the drop-down list in 'From Audio Device' or 'To Audio Device' blocks.
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Signal Generation 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
