how to update the value of a transfer function block during run time of simulation

7 次查看（过去 30 天）
Raghu
Raghu 2013-11-1
回答： Divyaansh Singh 2019-12-20
Example MY transfer function block contains (-kps-ki)/s. Here i need to update the value of kp and ki based on the input(U) to this block. (or) if U < x (some value) need to set kp=0;ki=y else need to set kp=z;ki=0;
Thanks in advance, Raghu.

请先登录，再回答此问题。

回答（2 个）

Jonathan LeSage
Jonathan LeSage 2013-11-4
Here is a link to some documentation that details several different methods in Simulink to achieve what you're looking for:
The most straightforward method is likely option (3). You can construct the transfer function models via fundamental Simulink blocks with your 'Kp' and 'Ki' values as inputs. You can changes these values according to the necessary logic that you describe above.
Hope this helps to get you started!
Divyaansh Singh
Divyaansh Singh 2019-12-20
My transfer function block is not updating whe i try to change the values , it give sproper result whatsoever . but i am not able to see changes in the block . All it does is converts to num(s)/den(s).Dobut.JPG

类别

在 Help Center 和 File Exchange 中查找有关 Modeling 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by