How can I use NI-PCI-6010 DAQ Device in Simulink?
显示 更早的评论
Hello there,
I have bought National Instruments PCI-6010 DAQ Device as I see it in the supported hardware list.
Even though it is shown in the list that PCI-6010 is available for both session and legacy interfaces, i could not find it under Install New Board tab of any Real-Time Windows Target library blocks.
I have checked every single option in there. Is there any way to use it, or is PCI-6010 not compatible with Simulink?
I am using MATLAB R2012a by the way.
采纳的回答
Zack Peters
2013-11-6
0 个投票
The Data Acquisition Toolbox does support the NI PCI-6010, as you have linked above. However, Real-Time Windows Target does not, which you can see from the following link:
If you are looking to use the NI PCI-6010 in Simulink, this can be done with the Data Acquisition Toolbox library. The library can be opened by typing daqlib in the command window.
~Zack
2 个评论
Baris
2013-11-6
Zack Peters
2013-11-6
Currently the daqlib is only supported for the legacy interface on 32-bit MATLAB.
It may be possible for you to obtain or download a 32-bit version of MATLAB from our website.
~Zack
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Target Computer Setup 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
