How can I use NI-PCI-6010 DAQ Device in Simulink?

3 次查看（过去 30 天）
Baris
Baris 2013-11-6
评论： Zack Peters 2013-11-6
Hello there,
I have bought National Instruments PCI-6010 DAQ Device as I see it in the supported hardware list.
https://www.mathworks.com/products/daq/supported/ni-daqmx.html
Even though it is shown in the list that PCI-6010 is available for both session and legacy interfaces, i could not find it under Install New Board tab of any Real-Time Windows Target library blocks.
I have checked every single option in there. Is there any way to use it, or is PCI-6010 not compatible with Simulink?
I am using MATLAB R2012a by the way.

请先登录，再回答此问题。

采纳的回答

Zack Peters
Zack Peters 2013-11-6
The Data Acquisition Toolbox does support the NI PCI-6010, as you have linked above. However, Real-Time Windows Target does not, which you can see from the following link:
Real-Time Windows Target Supported Hardware
If you are looking to use the NI PCI-6010 in Simulink, this can be done with the Data Acquisition Toolbox library. The library can be opened by typing daqlib in the command window.
~Zack
  2 个评论
Baris
Baris 2013-11-6
Thank you for the answer, I am using 64-bit MATLAB, so i think I cannot use 'daqlib' command neither. Is there another solution to deal with it?
Zack Peters
Zack Peters 2013-11-6
Currently the daqlib is only supported for the legacy interface on 32-bit MATLAB.
Supported Hardware - National Instruments- NI-DAQmx
It may be possible for you to obtain or download a 32-bit version of MATLAB from our website.
~Zack

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Target Computer Setup 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by