How do I disable warnings about scope signals in referenced models (Simulink)?

Question

Matt 2013-11-8

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/105311-how-do-i-disable-warnings-about-scope-signals-in-referenced-models-simulink

评论： Matt 2013-11-19

Using Simulink in Matlab 2011b, I get warnings like the following:

tb_SAR_ADC8x/Model|SAR_ADC8X/Model5:  Warning: The model 'SAR_ADC_flat' is referenced in Normal mode
and contains the Signal Viewer scope 'SAR_ADC_flat/Scope'. This scope can display signals only if the
scope is already open when simulation begins.

I want to keep my scope signals in the sub-models for debugging them, yet I am ok that I don't see them when I reference these models in a higher level model. But I don't want a ton of useless warnings about it.

I've tried to turn off these warnings by setting Configuration...->Diagnostics->Model Referencing->Unsupported Data Logging to 'none', which from the docs seemed like it concerned signals sent to a scope too. But this brought me no luck.

Any idea how to get rid of these warnings in referenced models, hopefully without removing all the signals from the scope in the referenced model?

thanks, Matt

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Zack Peters 2013-11-9

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/105311-how-do-i-disable-warnings-about-scope-signals-in-referenced-models-simulink#answer_114656

Hi Matt,

If you cannot find it within the model's configuration parameters -> diagnostics pane, then I would take a look at our documentation and examples on "Suppressing Warnings".

~Zack

2 个评论
显示无隐藏无

Matt 2013-11-19

Thanks! I used the technique on the "Suppressing Warnings" doc that you linked to. It's a very general and broadly-useful mechanism I didn't know about before.

Matt 2013-11-19