I can not connect my arduino to MATLAB

18 次查看（过去 30 天）
Hien Ngoc
Hien Ngoc 2013-11-10
评论： Chalachew Werku 2021-2-14
>> a=arduino('COM5'); Attempting connection ............. Warning: Unsuccessful read: A timeout occurred before the Terminator was reached. Error using arduino (line 104) Connection unsuccessful, please make sure that the board is powered on, running a sketch provided with thepackage, and connected to the indicated serial port. You might also try to unplug and re-plug the USB cable before attempting a reconnection. Please tell me how to fix this error, i used Matlab 2013a, does it support this feature?

请先登录，再回答此问题。

采纳的回答

Rolfe Dlugy-Hegwer
Rolfe Dlugy-Hegwer 2013-11-10
Which sketch are you using? During the mean time, please try this workaround.
  2 个评论
Hien Ngoc
Hien Ngoc 2013-11-10
I am using "the blink led" sketch during the time . But it still does not run.
Hien Ngoc
Hien Ngoc 2013-11-11
Thank you so much, I open a file PDE in Arduino IDE, ok, it runs well

请先登录，再进行评论。

更多回答（1 个）

Brais Gonzalez
Brais Gonzalez 2017-11-21
Answer for Error using arduino (line 104) Warning: Unsuccessful read: A timeout occurred before the Terminator was reached.
The answer is: 1 In the Arduino software(IDE). You need write the code, which you find in file "adioes.pde" There are three files adio, adioe, adioes. A for analog D for digital I for input O for Output E for encoder S for Servo. If you need a Servo o a encoder, you need put the code more complete adioes. 2 Compile this code and send to arduino. Close the IDE 3 To open matlab and to write a=arduino("COMxx") 4 You has finalized the Arduino instalation
  2 个评论
Mohammed Zaid Khan
Mohammed Zaid Khan 2020-9-3
thanks, i faced the same problem. I sought out the problem with your method. Thanks a lot.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Arduino Hardware 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by