Doubt in Ideal Switch

2011 6 30
2 个回答
更新时间：2014 12 5
6 次查看（30 天）

0 个投票

In Ideal Switch, if g=0 the switch are closed and if g=1 are open, sure?

请先登录，再回答此问题。

回答（2 个）

Arnaud Miege
Arnaud Miege 2011-7-1

1 个投票

Are you referring to the Ideal Switch from SimPowerSystems? If so, look at the documentation:
"The Ideal Switch block is fully controlled by the gate signal (g > 0 or g = 0). It has the following characteristics:
  • Blocks any forward or reverse applied voltage with 0 current flow when g = 0
  • Conducts any bidirectional current with quasi-zero voltage drop when g > 0
  • Switches instantaneously between on and off states when triggered"
HTH,
Arnaud
Obinna
Obinna 2014-12-5

0 个投票

Hello, I tried using the "ideal Switch" block in Simpowersystems. I conneceted it to a battery I coded a matlab function block with if commands to give instructions to the switch via the gate(which is a simulink in put signal) to toggel between off and on. But it does not work.
so see what I did.
in the matlab function block
i did if command as follows,
if u==1 y=0; else y=1; end
but when i pass "1" through it still outputs the voltage in the battery. I have the voltage measurement between the switch and the negative port of the battery. so I have a display attached to the voltage measurement.
Please assist me with this issue.
thanks.

类别

在 帮助中心 和 File Exchange 中查找有关 Electrical Sensors 的更多信息

产品

标签

提问:

Nuno
Nuno
2011-6-30

回答：

Obinna
Obinna
2014-12-5

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by