How to fill blood vessel pixels

1 次查看（过去 30 天）
Arslan Ahmad
Arslan Ahmad 2013-11-24
回答： Image Analyst 2013-11-24
I want to fill the blood vessel pixel with 1's and at the same time I want to remove the noisy little spots from the image. This image is obtained after the application of canny edge detector to source image. I will be grateful for your help.

请先登录，再回答此问题。

采纳的回答

Image Analyst
Image Analyst 2013-11-24
Maybe Canny is not the way to go. Is that one of the methods listed in section 20.5 here: VisionBib ophthalmology articles, or are there better methods listed? Don't waste time on a method known to be not very good. Find a published one that works, and then improve it if you want. If you're doing this for graduate research, you can't publish a paper on some old elementary algorithm. You either have to invent a new one or improve on an existing one.

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Biomedical Imaging 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by