How to observe the output of the Modelsim blockset using scope?

2 次查看（过去 30 天）
Milruwan
Milruwan 2013-12-30
编辑： Milruwan 2013-12-31
I simulate a matlab co simulation project using modelsim. I created a fixed point filter using fdatool and co simulate it. I successfully observed the output from the modelsim but the matlab scope gives a blank output. what is the reason? How can I observe the output using scope?

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Simulink 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by