How to respond to following message which is obtained while trying to generate the bitstream file of a simulink file including xilinx blocks? Please guide me.

Question

vanama namasivayam 2014-1-3

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/111333-how-to-respond-to-following-message-which-is-obtained-while-trying-to-generate-the-bitstream-file-of

回答： vanama namasivayam 2014-9-6

INFO:ProjectMgmt - Parsing design hierarchy completed successfully.

INFO:TclTasksC:2116 - The automatic calculation of top has been turned-off.

   Please set the new top explicitly by running the "project set top" command.
   To re-calculate the new top automatically, set the "Auto Implementation Top"
   property to true.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Chandrajit Pal 2014-7-2

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/111333-how-to-respond-to-following-message-which-is-obtained-while-trying-to-generate-the-bitstream-file-of#answer_143376

I am getting the same problem...did u get ur error solved?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

Answer 2

vanama namasivayam 2014-9-6

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/111333-how-to-respond-to-following-message-which-is-obtained-while-trying-to-generate-the-bitstream-file-of#answer_150932

When I got this err, In the report file after partial bit stream generation is over I got another err. mentioned about the size being too large to fit into the device.So I got the successful bit stream file after reducing the device utilization but I could not follow anything about the err. what I mentioned.