National Instruments Data Acquisition Software Error Status Code: -89136

6 次查看（过去 30 天）
go9kata
go9kata 2014-1-16
编辑： Walter Roberson 2016-10-13
Hi guys,
This question was asked before but without any answer, so I wanted to reopen it and I am looking forward any tip:
I just connected NI PXIe-1073 chassis with integrated module NI PXIe-6361. I installed the NI-DAQmx 9.8 driver and I am using MatLab R2013b (8.2.0.701) with DAQ Toolbox Version 3.4.
In the NI MAX (Measurement & Automation Explorer) the modules are recognised after connection and the self-test options runs with success result.
From MatLab I wanted to try the demo for Getting Started with Session-Based Interface Using NI Devices:
http://www.mathworks.de/de/help/daq/examples/getting-started-with-session-based-interface-using-ni-devices.html?prodcode=DA&language=en
Matlab recognises the devices, it creates a session, but once the call s.startForeground() it throws the following error:
NI Error -89136:
Specified route cannot be satisfied, because the hardware does not support it.
Property: DAQmx_RefClk_Src
Requested Value: /PXI1Slot2/PXI_CLK10
Task Name: _unnamedTask<158>
Status Code: -89136
If I checked in the connections of the created session, they are empty. On the NI MAX site I checked the Device Routes map and the /PXI1Slot2/PXI_CLK10 is marked with yellow colour, meaning an indirect route. I have no idea how to approach the problem so any hint and clue will be highly appreciated!
Thank you in advance! ;)

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Data Acquisition Toolbox Supported Hardware 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by