Can I change the name of a parameter of a existing simulink block?

Question

Bou 2014-1-21

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/113132-can-i-change-the-name-of-a-parameter-of-a-existing-simulink-block

回答： Kaustubha Govind 2014-3-27

Hello,

I want to change the name of a/the parameter of a PS Constant block. I want to change it from 'constant' to 'constant1'.

Is this possible?

When I go to the Mask-Parameters I cant adjust anything because it is read only. Can I maybe make my own block, copy all properties of the PS Constant block into it and only change the parameter name?

Thanks in advance!

Greetings Boudewijn

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Kaustubha Govind 2014-3-27

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/113132-can-i-change-the-name-of-a-parameter-of-a-existing-simulink-block#answer_130725

You can't change the name of the parameter, but you can add another mask on top of the block and create a new set of parameters that map to the ones on the mask below. (In newer releases, this mapping can be done automatically by promoting block parameters to a mask)

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

Answer 2

ES 2014-1-21

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/113132-can-i-change-the-name-of-a-parameter-of-a-existing-simulink-block#answer_121636

在 MATLAB Online 中打开

you can use a set_param to set all the properties of a block.

set_param(BlockPath,'PropertName','PropertyValue');
for ex:
to set block name,
set_param(BlockPath,'BlockName','Constant1');

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Bou 2014-1-21

Thanks, but i dont want to change the name of the Block. I want to change the name of a Parameter.

So for ex: The name of the PS Constant block is Irradiance. The Parameter name is constant. I want to change the name of the parameter 'constant', not the value!

请先登录，再进行评论。