Simulink display block as stateflow output

3 次查看（过去 30 天）
Dlav
Dlav 2014-1-27
回答： Chandrasekhar 2014-4-1
Hi, I have following problem, hope some one can help me to solve it. I have Simulink model with Stateflow chart inside. I wish to see all Stateflow outputs using Dispaly block, but it only shows me last output. If I connect Scope I can see all outputs. So question is that I need to do to see all stateflow outputs on the scope.
Thank you.
Regards
  1 个评论
Kaustubha Govind
Kaustubha Govind 2014-3-31
When you say all outputs, do you mean that you have multiple outputs, or that you'd like to see all time-samples for one output signal? If it is the latter, I don't think a Display block would be appropriate.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Chandrasekhar
Chandrasekhar 2014-4-1
Display block can be used only to see the latest output.but if you want to see how the output varies over a period of time then scope should be used. if you have multiple signals of same data type and wish to watch them in a single scope, then multiplex the signals using a mux block and give it to scope.

类别

在 Help Center 和 File Exchange 中查找有关 Simulink Functions 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by