Data overshoot in FPGA implementation

Question

Krishnakumar 2014-1-28

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/113965-data-overshoot-in-fpga-implementation

评论： Krishnakumar 2014-1-29

Hi,

I am implementing a QAM 16 transmitter on FPGA.I can see data overshoot abruptly at various time instants in transmitted signal.But these overshoots were not observed in either Simulink simulation,Model Sim cosimulation or Black box simulation.The VHDL code was generated from Simulink model by HDL coder.Please make some suggestions to solve the issue and help me to find possible reasons for this.

Krishnakumar

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Bharath Venkataraman 2014-1-28

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/113965-data-overshoot-in-fpga-implementation#answer_122456

Where are you seeing these overshoots? Is it during transmission with an RF transmitter? One suggestion is to try to loop back the data back to Simulink/the desktop from the FPGA. If you see that the loopback data looks right, you may need to check your RF card specification.

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Krishnakumar 2014-1-29

Sir,

I see the overshoot when I observe captured data from FPGA using chip scope software in computer screen. But such spikes are not seen in any simulation or cosimulation.The RF side is not overlooked now.

Krishnakumar

请先登录，再进行评论。