How to programatically send Update Diagram command to Simulink

79 次查看（过去 30 天）
Paulo Silva
Paulo Silva 2011-7-15
评论： Jyoti Sachdeva 2023-10-29
I stumble upon a problem in my project, there's one GUI that controls the simulation and that GUI changes variables on MATLAB workspace, the same variables are used in the simulation but simulink doesn't read the new values unless the simulation stops and starts or the Update Diagram command is issued, so the question is how to force simulink to Update Diagram in my code?
Already tried:
eval([SimFileName '([],[],[],''update'')' ]);
but it doesn't do what I want.
Meanwhile I found one solution but it's using QuaRC MATLAB Functions, would be better to have something withing simulink functions.
qc_update_model
Any help is welcome, thanks
  3 个评论
显示 1更早的评论
Paulo Silva
Paulo Silva 2011-7-15
No, the GUI just changes values of the variables on the workspace and the simulation files and other tools (to calculate performance parameters) use those variables.
Vinol Joy D'souza
Vinol Joy D'souza 2011-7-19
I want to change the parameters of a block when the model is running and simultaneously see the changes in the output.
For eg.I have a sine block connected to a Scope.and when i start the simulation.I want to change the frequency of the sine wave and see the corresponding frequency changed wave on the scope output.I want to do this as i want to see how my model behaves for different frequencies...HOw do i do this???

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Fangjun Jiang
Fangjun Jiang 2011-7-15
Use set_param('sys', 'SimulationCommand', 'cmd')?
where 'sys' is the name of the system and 'cmd' is 'start', 'stop', 'pause', 'continue', 'update', or 'WriteDataLogs'
  3 个评论
显示 1更早的评论
Vinol Joy D'souza
Vinol Joy D'souza 2011-7-19
I want to change the parameters of a block when the model is running and simultaneously see the changes in the output.
For eg.I have a sine block connected to a Scope.and when i start the simulation.I want to change the frequency of the sine wave and see the corresponding frequency changed wave on the scope output.I want to do this as i want to see how my model behaves for different frequencies...HOw do i do this???

请先登录，再进行评论。

更多回答（2 个）

Noam Greenboim
Noam Greenboim 2017-7-11
set_param(bdroot,'SimulationCommand','Update')
  2 个评论
Jyoti Sachdeva
Jyoti Sachdeva 2023-10-29
Instead of using bdroot,
mdlName = MotorCtrl.slx
set_param(mdlName,'SimulationCommand','Update')
This command is equivalent to programatically running Ctrl+D on MotorCtrl.slx model.

请先登录，再进行评论。

Rick Rosson
Rick Rosson 2011-7-15
Hi Paulo,
Although not ideal, the following line of code should work:
Simulink.BlockDiagram.getSampleTimes(SimFileName);
Make sure that the value of SimFileName excludes the .mdl extension, and that the file is already open at the time of the call.
HTH.
Rick

类别

在 Help Center 和 File Exchange 中查找有关 Programmatic Model Editing 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by