Optimtool for nonlinear constrained optimization - Bounds on design variables
显示 更早的评论
Hello,
i am using Optimtool for nonlinear constrained optimization.
After writing down two separated files for the objective function and the set of nonlinear constraints, it must be indicated also the lower and upper limits for each of the n-design variables x(1),x(2),...,x(n).
Suppose that x(1) [0.001, 0.05]; and x(2) = [0.7,2];
How one should indicate this? is is correct to write: lb =[0.001, 0.05] and ub = [0.7 2] ?
thanks
采纳的回答
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Problem-Based Optimization Setup 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
