Problem with Enable subsystem in simulink
显示 更早的评论
I am simulating a Switched reluctance machine having 4 phases. Each phase is an enabled subsystem enabled by control signals generated from angle feedback. The problem is that even though the control signal is a pulse waveform varying from 0 to 1, the enable signal inside the subsystem is always shown to be 1 (observed from 'show output port'). This means the subsystem is always being enabled.
I am unable to resolve this issue. Please help asap.
回答（1 个）
Chandrasekhar
2014-3-21
编辑：Chandrasekhar
2014-3-21
0 个投票
The output of the enable subsystem holds the value even if the subsystem is disabled. If you want to reset the output value do as shown in figure below
1 个评论
avinash3010
2014-3-21
I looked into this.I want to use the enable signal within the subsystem, not as an output.
the enable signal outside the block is
but inside the block it is always 1
类别
在 帮助中心 和 File Exchange 中查找有关 Subsystems 的更多信息
2014-3-21
2014-3-21
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
