Simulink very slow when changing configuration/block parameters
7 次查看(过去 30 天)
显示 更早的评论
Hello all,
our university recently upgraded matlab to 2011a. However, I noticed some odd behavior in two cases:
1) after exiting the configuration parameter dialog box, it takes 4-5 seconds before I regain control over the simulink window. This happens even if the simulation is currently stopped.
2) if the simulation is running, and I want to change a block's value (say a constant value block), it takes the same amount of time before I can actually change the value, and again a few seconds after I apply the change before I can get back to the main simulink window. This does not happen if the simulation is not running.
This behaviour can be seen even with a very simple scheme with one matlab function, one scope and a constant value.
This was not the case with the previous version we were using (2006b).
I noticed this behavior under Win7 x64, and WinXp 32. However, the Linux version seems to run fine.
Is there anything that can be done to solve this issue?
0 个评论
回答(2 个)
Fangjun Jiang
2011-8-3
No idea. It might be that the computer hardware is no matching for the new software anymore. I have a laptop. It runs R2007b Okay. But it takes more then a minute to start R2010b. Even exiting R2010b takes a long time. I can only wish I'll get a new computer soon.
Vivek
2013-4-10
Hi, Just curious, have you guys been able to resolve this issue? I am facing similar problems and am using win7-64bit, Matlab 2011a. The bus-creator block is also so slow!
THanks,
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Simulink Functions 的更多信息
产品
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!