清空筛选条件
清空筛选条件

MATLAB fnc to control PWM generator

10 次查看（过去 30 天）
Stephen
Stephen 2011-8-14
评论： Janani Baskaran 2016-11-10
How can I use a duty cycle result from a MATLAB fnc to control the duty cycle of a PWM generator, using Simulink.

请先登录，再回答此问题。

回答（3 个）

Stephen
Stephen 2011-8-14
I got it working... it was a scale problem. Instead of duty cycle = 0 to 1, my MATLAB fnc was outputtng duty cycle = 0 to 100.
After fixing my problem, I simply connected the MATLAN fnc to the input of the PWM generator and success.
  2 个评论
Hossein
Hossein 2011-12-9
can you do this in simscape also?with Controlled PWM Voltage ?
Janani Baskaran
Janani Baskaran 2016-11-10
Hi can you tell me how to control the duty cycle of PWM using the output from PID Controller in Simulink.

请先登录，再进行评论。

bijeta Chakraborty
bijeta Chakraborty 2012-3-11
Hello Stephen,
Can you please guide me as to how you can control a Duty Ratio of PWM in Simulink by using the stored values of Duty Ratio from MATLAB.
Looks like you have already done this so please help ? Any inputs would be helpful.
regards bijeta
Shawn Chang
Shawn Chang 2012-6-19
Hi Stephen,
I wish to generate pwm signal and send it to the microcontroller through the serial communication. Can you aid me on how you generated the pwm signal? Thanks. Your help is much appreciate.
  1 个评论
Walter Roberson
Walter Roberson 2012-6-19
Serial communications protocols use fixed bit-widths, and so are not able to convey the variable pulse widths needed for Pulse Width Modification. Not unless what you send is a _description_ of the pulses.

请先登录，再进行评论。

社区

更多回答在  Power Electronics Control

类别

在 Help Center 和 File Exchange 中查找有关 Pulse width modulation (PWM) 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by