How to specify initial voltage or current of a series RLC branch when using power_statepace command?
1 次查看(过去 30 天)
显示 更早的评论
I can generate statespace representation of a circuit using 'power_statespace' command of matlab.
Eventhough 'power_statespace' outputs initial conditions of reduced states 'x0', I cannot specify the initial voltage of a capacitor or initial current of an inductor.
Doesn't 'power_statespace' command support specifying initial current or voltage of a series RLC branch?
0 个评论
回答(1 个)
Joel Van Sickel
2021-8-18
Hello,
I realize this answer is too late for the asker, but as part of a cleanup effort, I will be answering this question: This command actually computes initial values based on the topolgy and switching states so it will not necessarily use the initial conditions that you specify in the model.
Regards,
Joel
0 个评论
另请参阅
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!