configure closed-loop control system
显示 更早的评论
Im new to this sooo... help!
My simulink model shows the results of a tank system (2 tanks), the water levels h1 and h2. What do I have to do to make a closed-loop system out if. the bigger the h1 level the bigger the R2 flow, the same goes for the h2 and R3?
采纳的回答
Arkadiy Turevskiy
2014-7-7
0 个投票
It appears R1, R2, and R3 are the vales you want to control. So these or a subset of these should be controlled by a controller. For example, take a look at a simpler, but similar example where there is an inflow valve we use to control the water level.
1 个评论
Amir
2014-7-9
how can I make a figure according to that picture above? I just want the fluid levels to be shown in the figure in real-time, the scope values to be shown for both tanks, something like in this picture below.
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Real-Time PID Autotuning 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
