Table comparing Session Based Interface and Legacy Interface on daq toolbox

3 次查看（过去 30 天）
Rabindra
Rabindra 2014-7-1
回答： Irina 2024-6-4
Is there a complete list of daq commands that shows the Session-based command for corresponding Legacy Interface ? For example, 'daqhwinfo' there is a small grey box note that says:
"Note: You cannot use the legacy interface on 64–bit MATLAB. See Using the Session-Based Interface to acquire and generate data."
It would be nice if this links to corresponding Session-based command instead of leaving us trying to figure it out. Very annoying.
Does such a list exist where I can search for legacy command and find corresponding session-based command ?

请先登录，再回答此问题。

回答（2 个）

Sruthi Ayloo
Sruthi Ayloo 2014-7-7
There is no direct mapping for every command in Legacy based Interface to Session based Interface. But, the table in the following link might be helpful.
http://www.mathworks.com/help/daq/transition-your-code-to-session-based-interface.html
Irina
Irina 2024-6-4
Hello,
Where I can found information about transition of matlab code for gui from R2007 to R2018 version? Script seems to works in session-based interface after transition, but there are error messages when I am pushing bottoms in gui.

类别

在 Help Center 和 File Exchange 中查找有关 National Instruments Frame Grabbers 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by