Simulation Running too slow

2011 8 18
1 个回答
11 次查看（30 天）

0 个投票

I am trying to do a simple power system simulation. I just need to view the rms value of current. But since, the simulation is running very slow at steps of 1e-8 seconds, I am only getting instantaneous value. How to just solve the circuit for steady state condition? Here is a picture https://lh4.googleusercontent.com/-tBjv-eZlM2I/Tk1auvIklLI/AAAAAAAAA80/YeXeE8z1q0A/s800/too_slow.JPG

2 个评论
显示 无 隐藏 无

Fangjun Jiang
Fangjun Jiang 2011-8-18
Any particular reason using such a small step size? What is the frequency of the signal that you are simulating?
Rajendra
Rajendra 2011-8-19
I am not using any step. It automatically does that. I simply hit run. Its 60 hz ofcourse.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Fangjun Jiang
Fangjun Jiang 2011-8-19

0 个投票

I don't have that Toolbox. I remember reading some posts here that the simulation step is variable step. I think you can go to menu Simulation->Configuration Parameters ...Solver to set up the maximum step size. Step size of 1e-8 seems to small. 1e-3 sounds more reasonable.

2 个评论
显示 无 隐藏 无

Rajendra
Rajendra 2011-8-19
I just tried setting the min step size (which was previously set to auto) to 0.001.
But when simulating, I get this error message
Derivative input 1 of 'transmission/RMS/integ' at time 0.002200000000000017 is Inf or NaN. Stopping simulation. There may be a singularity in the solution. If not, try reducing the step size (either by reducing the fixed step size or by tightening the error tolerances).
Fangjun Jiang
Fangjun Jiang 2011-8-19
Okay. There might be some dynamics that require small step size. To find out, you can choose fixed step size and then try-and-error a few times, form 1e-4 to 1e-5, 1e-6, etc.

请先登录，再进行评论。

类别

在 帮助中心 和 File Exchange 中查找有关 Programming 的更多信息

标签

提问:

Rajendra
Rajendra
2011-8-18

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by