Using checkboxes in GUI to select which functions run
1 次查看(过去 30 天)
显示 更早的评论
I am creating a gui in which I want to have several check boxes to control which wavelets are used for the wavelet transforms of an ecg signal. In otherwords, each checkbox is separate function, but I want a single pushbutton then to set off the functions that are checked. Is there a way to do this so that only the checked check boxes run when the pushbutton is pressed?
0 个评论
采纳的回答
Joseph Cheng
2014-7-3
At the beginning of the pushbutton function have it do a check for which checkboxes are checked off. then use that data to set different flags either perform or skip over those wavelet transforms.
1 个评论
Joseph Cheng
2014-7-3
编辑:Joseph Cheng
2014-7-3
function pushbutton_callback(______)
wavelet1 = get(handles.checkbox1,'value')
wavelet2 = get(handles.checkbox2,'value')
wavelet3 = get(handles.checkbox3,'value')
%etc.
%if statements checking each wavelet.
% or you can also do a for loop to go through something like this.
wavelets = [wavelet1 2*wavelet2 3*wavelet3....];
%multiplication if you leave the default 0 and 1, or change each checkbox to be a specific max value.
for wave = 1:length(wavelets)
switch wavelets(wave)
case 1
wavelet1_function()
case 2
wavelet2_function.
otherwise
continue;
end.
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Signal Analysis 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!