Model simulink block connection with different simscape

Question

0 个投票

I am trying to connect a converter model to a grid model. The problem is the grid model was created in old matlab version by using PowerSimSystem. The pictures show how it does not allow me to connect the switch (out side the subsystem) to the current sensor(inside subsystem). Is there any solution for this situation? Any suggestion for another blocks that I could use instead or with my model.

2 个评论
显示无隐藏无

SALAH alatai 2021-8-18

Because the blue line one and the black one from different library can't connect them together, try to find the same block from same library.

Rawaa Almajeez 2021-8-18

Do you mean to replace the switch?Would you please give me more details

请先登录，再进行评论。

请先登录，再回答此问题。

Follow Question

Answer 1

Joel Van Sickel 2021-8-18

0 个投票

Hello Rawaa,

you can combine the two technologies as Pemendra says, there are four blocks with names like this "Voltage-Current

Simscape Interface"

However, combining specialized power systems with these blocks will yield a model that is hard to maintain and simulate. It is better to stay in one technology or the other. In this case, just build your new model using specialized power systems components instead of simscape componets. Specialized power systems is included in the Simscape electrical toolbox.

Regards,

Joel

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Rawaa Almajeez 2021-8-18

Thank you so much. I already tried to use Voltage-Current Simscape interface, but it did not work. The best choice for me right now to build a new model as you advice me.

请先登录，再进行评论。