Anticipation on setpoint with model predictive control

7 次查看（过去 30 天）
Morvan
Morvan 2021-8-30
回答： Joe Gibbs 2024-6-11
Hello !
I am starting to use the Model Predictive Control Toolbox. And facing a problem...
I would like to anticipate the setpoint change, but can't manage to achieve that at the moment. The MV (manipulated variable) starts to move only at the time of the step on the setpoint. (In my opinion, the MPC controller should start to move the MV when the step change enters the prediction horizon (?)). See in the figure below the result I get in the MPCDesigner, and in red the results I would like to get (sorry for poor drawing...).
Thank you for any help with that toolbox ! :)
Morvan

请先登录，再回答此问题。

采纳的回答

Morvan
Morvan 2021-8-31
I actually found the solution in the MATLAB documentation. It is not very easy to find in my opinion, but not that hard... (sorry for asking too fast maybe).
It is here:
Use MPCSIMOPT object to turn on previewing feature in the closed-loop simulation.
params = mpcsimopt(mpcobj);
params.MDLookAhead='on';
params.RefLookAhead='on';
Hope that can help someone like me in the future ! :)
Morvan

更多回答（1 个）

Joe Gibbs
Joe Gibbs 2024-6-11
Just to provide additional resources for this question for those using the MPC block or MPC Designer in Simulink, the following "Signal Previewing" page presents the method for enabling preview or anticipation for reference inputs or disturbances in the event that these are partially observable.
https://uk.mathworks.com/help/mpc/ug/signal-previewing.html
Hope it's useful for someone in the future!

类别

在 Help Center 和 File Exchange 中查找有关 Model Predictive Control Toolbox 的更多信息

标签

产品


版本

R2019b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by