Is there a way to use a mass flow rate source and define the pressure differential across a closed loop two phase pipe system?

2 次查看（过去 30 天）
Delika Weragoda
Delika Weragoda 2021-9-2
评论： Yifeng Tang 2022-12-29
Hi,
I'm trying to define flow through a two phase pipe using a mass flow rate source and to set the pressure differential in a closed loop pipe system using a pressure source along with a infinite flow restriction. But, I find that the model triggers an error exceeding maximum pressure limitations in the domain.
Any thoughts on this please.
Many thanks
  1 个评论
Yifeng Tang
Yifeng Tang 2022-12-29
Usually you may use source blocks to specify either the flow OR the pressure difference over a component. The resulting pressure drop or flowrate is then calculated based on the equations and parameters of the component. If you feel you have to specify both the flow and the pressure to replicate what you observe in the actual component, it's more likely that you don't yet have the actual parameters or physics of the component in the model yet.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Sources 的更多信息

标签

产品


版本

R2019a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by