Pixhawk unable to send PWM / arm

2021 9 4
1 个回答
回答已采纳
更新时间：2021 9 4
60 次查看（30 天）

0 个投票

I have the pixhawk 1 and using connectedIO with the px4demo_PWM I am unable to send consistently PWM signals on the main out. If I plot the actuator outputs (uORB message), they occasionally jump to the commanded value but then returns to the fail safe value. I do not have a safety switch but have set the CBRK_IO_SAFETY=22027, and I have checked using the PX4 Parameter Read block that this value is actually set. I have also checked that starting the pixhawk without the SD card, that I can arm without the safety switch. I also tried to read the uORB safety message, and the safety_off value is 0. What is going wrong here, and how do I get to write the PWM?

请先登录，再回答此问题。

 采纳的回答

Rasmus
Rasmus 2021-9-4

0 个投票

I managed to fix the issue by adding the following to the rc.txt on the SD card:
-------- rc.txt --------
....
usleep 1000
px4io safety_off
usleep 1000
px4_simulink_app start
...
-------- rc.txt --------

更多回答（0 个）

类别

在 帮助中心 和 File Exchange 中查找有关 Simulink 3D Animation 的更多信息

产品

版本

R2021a

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by