sim command not opening Simulink model but workspace shows output variable ans ?!
显示 更早的评论
What I'm tryin to do is to run a Simulink file from Matlab script so that I don't have to open it seperately. My Simulink model takes values from Matlab's workspace. So what I indent to do is run the maltab which put the variable with values into workspace, then run (simulate) the simulink model from matlab script only.
I'm using sim command but it doesn't seem to work (not running the simulink model), but there's this ans variable that shows up in workapsace area that is of no use to me. I'ven't used any "To Workspace" block either.
采纳的回答
Walter Roberson
2021-9-6
1 个投票
The graphical part is interface. The computation part is what is triggered when you run sim() . Part of running a simulation might be to update inputs to a graphing block, but that does not mean that it is mandatory that the blocks appear on the screen.
Using Simulink Scopes and similar is not like using figure() and so on, in that using figure() always causes a window to pop up. Simulink Scopes record data, and will display it if you open the graphical interface -- but the graphical interface is not necessary for the model to run.
You can use commands such as get_param and related to get the state of blocks.
You can log signals.
Especially if you have configured Single Output, https://www.mathworks.com/help/simulink/gui/single-simulation-output.html then the output of sim() is a Simulink.SimulationOutput object that holds the result of the simulation, and with the way you are running, that is going to get stored in ans . You should assign the value to a variable and examine it to see what went on with your model.
3 个评论
Suraj Singh
2021-9-7
Thank you sir, I got your point have made a small change in my script that does solve my issue of getting the value from simulink model into workspace and using that.
What I did to open and simulate my model is first open the model by just writing the model name (w/o any prefix(command) and extension name). and then using out result to calculate further values in script.
Thanks & Regards
Suraj S. Danu
Walter Roberson
2021-9-8
The better approach would be to use
open_system Motor_Modelling
Suraj Singh
2021-9-8
更多回答（1 个）
Esen Ozbay
2021-9-6
Is it possible that you have created a variable or another function with the same name? Try the command
which sim
to see what MATLAB is calling when you execute.
类别
在 帮助中心 和 File Exchange 中查找有关 Event Functions 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
