In scenarios where multiple Simulink models are involved, what I like to do is summarised in the following points:
- I save the relevant parameters of a model in a MAT file using the “save” function.
- Under the “callbacks” section present in the “Model Properties” in “Modelling” tab in the “InitFcn”, I load the same MAT file using “load” function.
Here, if two models have parameters with same name, since the “initFcn” is called each time before the model is updated, the parameter for the current model will be loaded. Hence avoiding any error with values.
Tip: If you change the parameters value, in “ClosedFcn”, you can save the MAT file again to update your parameters.
Here is a documentation page, you can refer this for getting more information about Model callbacks:
