How do end a task on Zynq when using "Build, Deploy and& Start"?

1 次查看（过去 30 天）
丹 姚
丹 姚 2021-9-26
Hello all,
I uses Matlab 2020b and Xilinx Zynq UltraScale+ MPSoC ZCU102 evaluation kit for model based development.
I found that when I building ARM executable, "Monitor &Tune" will start a task that follows my "Stop Time", but when I use "Build, Deploy and& Start", the task will not stop until I powered off my Zynq board.
So how to build a task with stop time on Zynq when using "Build, Deploy and& Start"?
Thanks a lot

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Targeting FPGA & SoC Hardware 的更多信息

标签

产品


版本

R2020b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by