Derivative of state '1' in block 'matlab_function_MATHWORKS/CHERYL KNEE EXTENSION MODEL2/Integrator4' at time 0.918 is not finite. The simulation will be stopped.

Question

Saharul Arof 2021-10-2

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1465269-derivative-of-state-1-in-block-matlab_function_mathworks-cheryl-knee-extension-model2-integrator4

评论： Saharul Arof 2021-10-16

matlab_function_MATHWORKS.slx

While simulating Simulink model (attached) using mATLAB function contains control algorithm the simulation stop with errors "Derivative of state '1' in block 'matlab_function_MATHWORKS/CHERYL KNEE EXTENSION MODEL2/Integrator4' at time 0.918 is not finite. The simulation will be stopped. There may be a singularity in the solution. If not, try reducing the step size (either by reducing the fixed step size or by tightening the error tolerances) ".Please help.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Salman Ahmed 2021-10-11

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1465269-derivative-of-state-1-in-block-matlab_function_mathworks-cheryl-knee-extension-model2-integrator4#answer_805836

编辑：Salman Ahmed 2021-10-11

Hi Saharul,

This error has occured due to the presence of a NaN value at the input of the integator. To ascertain this, you can set the diagnostic "Inf or NaN block output" to error in the configuration settings. It shows the Zero4 block is the one which has produced this value. You could bypass the NaN values using a suitable condition based on your model. Hope it helps.