Conversion of Simulink Model to previous version

2 次查看（过去 30 天）
Siva Murugesan
Siva Murugesan 2021-10-4
评论： Siva Murugesan 2021-10-6
I have my models saved in 2020b version
Requsting the community members to support me for 2015a version

请先登录，再回答此问题。

采纳的回答

Jesús Zambrano
Jesús Zambrano 2021-10-4
Go to the Simulation Tab and do:
Then, select the release version:
  3 个评论
显示 1更早的评论
Jesús Zambrano
Jesús Zambrano 2021-10-5
Hey Siva, here you are.
Seems that exporting the RLC_Circuit model was OK, but the Noise_Filter model was partially converted. The error message says:
Block of type "dsp.LowpassFilter" uses functionality that is not available in Simulink R2015a and has been replaced with an empty subsystem.
Block of type "SpectrumAnalyzer" uses functionality that is not available in Simulink R2015a and has been replaced with an empty subsystem.
That's all I can do for you at this point. Otherwise, get R2020b! :-)
I suggets you contact the designer of those models and check the setting used for those two blocks, so you can run the model in R15a.
Best,
Jesús
Siva Murugesan
Siva Murugesan 2021-10-6
Hello Zambrano,
That's a bit to worry but thanks to you.
I will be able to take this further.
Thank you once again.
Regards,
Siva

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Modeling 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by