Receiving IMU data - Arduino and Simulink

1 次查看（过去 30 天）
Dylan
Dylan 2014-8-19
评论： arvind ramasamy 2018-8-16
I recently got the SEN0140 10 DOF IMU from DFRobot. I'm trying to upload a program to an Arduino Mega 2560 that will output the accelerometer, gyroscope and magnetometer data to an SD Card. This IMU uses an I2C interface, which has been my main problem. I cannot figure out how to receive the data from all three sensors simultaneously. Thanks to projects like this I have been able to receive the accelerometer and magnetometer data in Simulink to a scope, but not at the same time. At this point I'm completely lost. Any advice?

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Modeling 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by