how to flip the inputs of an simulink block

40 次查看（过去 30 天）

显示更早的评论

XAXRXTX 2014-8-27

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/152503-how-to-flip-the-inputs-of-an-simulink-block

评论： Star Strider 2014-8-29

Hi everyone

I have an integrator block, and I want to invert its inputs, so I explain

the first input is x the signal to be integrated (the top input)

the second input is y the initial condition (the bottom input)

I want that x became the bottom input and y the top input

thanks in advance

3 个评论
显示 1更早的评论隐藏 1更早的评论

XAXRXTX 2014-8-27

for example the cross product block you have two inputs A & B and one output C C = AxB the question is

how to put the A letter in the place of B input ...

A in the Top and B in the bottom of the block

after the inversion of the inputs

B in the Top and A in the bottom of the block

without affectiong the output

Andy L 2014-8-27

Does this need to be done based on a condition that is set during simulation?

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Andy L 2014-8-27

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/152503-how-to-flip-the-inputs-of-an-simulink-block#answer_149987

See the image below. A variable switches the input on the switch blocks - see switch for information on setting the input conditions. In this figure the input is switched by a constant but you could replace that to suit your needs (a signal generator for example).

So in this example whilst the switch variable is not greater than 0, input 1 is A, and 2 is B. When it is, these swap, A becoming the input to 2, and B becoming the input to 1.