Can I use an enabled subsystem to reset a signal generator?

2 次查看（过去 30 天）
Fernando
Fernando 2014-8-27
评论： 帅 2023-3-21
I have a signal generator (ramp) inside an enabled subsystem. I had hoped that I would be able to reset the signal generator when I disabled the subsystem. Unfortunately, this does not appear to work. I would like to be able to use the signal builder to build a signal and then use an enabled subsystem or some other technique to reset this signal when I trigger a particular event.

请先登录，再回答此问题。

回答（1 个）

Yu Jiang
Yu Jiang 2014-8-28
Hi Fernando
The attached model might be a workaround. Notice that in the subsystem, I double-clicked the enable block and change the "States when enabling:" to "reset". If you would also like to reset the output, you can double-click the out block in the subsystem and change "output when disabled" to "reset".
- Yu
  4 个评论
显示 2更早的评论
Chen Wu
Chen Wu 2021-8-26
Thanks, this also solve my question in https://www.mathworks.com/matlabcentral/answers/1439119-output-the-enable-signal-from-enabled-subsystems?s_tid=srchtitle

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Subsystems 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by