axis changing when plotting points
显示 更早的评论
Im plotting data on an axes using GUIDE. I have a loop where I use the plotyy command to plot 2 graphs, one point at a time. I want to set the axis as fixed which I have done, but wanted to do it once before the loop and have it remain.
It didn't work, so I have to reset the desired Y axis range on each iteration of the loop where I plot the data (one point at a time).
Is there a way where I can fix the axis, but still have the data plot one point at a time in a loop (so I can take the axis stuff out of the loop)?
Thanks Jason
采纳的回答
Adam
2014-9-18
You should be able to do this by setting:
set( hAxes, 'YLimMode', 'manual' )
( XLimMode or ZLimMode too if required )
and just set your limits before the for loop. Then they should not change as you plot new points, even if the new points fall outside the visible range.
更多回答（1 个）
Youssef Khmou
2014-9-18
One method to fix the issue is to place the axis command inside the loop, suppose the limits are :
L=[xmin xmax ymin ymax];
Inside the loop you write :
axis(L)
类别
在 帮助中心 和 File Exchange 中查找有关 Two y-axis 的更多信息
Translated by 
