makemid error: can't read driver function pannel
显示 更早的评论
I have a 64 bit windows machine, with NI-scope 3.8 installed and running just fine but can't get any further on the demo below because I get this error. I need to get data from a National Instruments PCI-5105 Digitizer board installed. I can operate the board with NI-Scope front pannel software. One other thing I have two drives and don't know if I need to set this toolbox to scan a diffrent drive for the drivers.
http://www.mathworks.com/products/instrument/demos.html?file=/products/demos/shipping/instrument/demo_niscope.html
1 个评论
Sam
2013-1-3
I have the same problem with Ni-Scope driver 3.9.7.
makemid('niScope') gives me error: The driver function panel could not be read.
When I try to import in midedit, I get "An error occurred while reading the file".
Any solutions?
回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Test and Measurement 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
