Event based CAN signal generation in Simulink

1 次查看（过去 30 天）
shripad
shripad 2014-10-10
评论： Avinash 2015-12-3
I want generate CAN transmitting signal in simulink, I am able to transmit CAN signal when certain even is occurred but when condition is not occurred or condition is not satisfy then CAN message should not be send through simulink. ( not even message with 00 data, that message should be completely disable)
please guide
Thanks
Reagrds Shripad

请先登录，再回答此问题。

采纳的回答

Shankar Subramanian
Shankar Subramanian 2014-10-15
Have you tried using conditional subsystems ?
  2 个评论
shripad
shripad 2014-10-16
yes..hopefully got the solution conditional subsystem works! Thanks
Avinash
Avinash 2015-12-3
I am facing the same issue. I tried with Enabled subsystem, but it keeps sending msgs when there is no enable signal based on states setting as held/reset. So i tried with triggered subsystem, it works but now the problem is, it stops sending messages when implemented for more than 15 subsystems even there is trigger for all together. Can you help me on this if anyone tried for big number of triggered subsystem with CAN send block inside?

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Signal Generation 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by