convert signal to morse code
显示 更早的评论
hello,
as part of my self project, I'm trying to do morse encoder and decoder from sound,
I'm at the part before the decoder, I'm receiving the signal from the spectrogram and I convert it to a "digital signal" that is equal to the morse code but I don't know how to convert it to dash, dot, and space between words
I received a signal (for example) after some counter manipulations to filter the spectrogram signal
this plot its vector of [1x1499 values]
and the value of code after: - . . . . -
isn't good enough because I want it exactly like this: - . ... -
- . ... - = test (t=- ,e=. ,s=... ,t=- )
and of course, I want to do it generic and not specific for this example morse combination code.
1 个评论
dpb
2021-11-9
That's a fairly clean-looking signal -- I think I'd try findpeaks to locate the peaks and the time delay between each. The peak magnitude >~80 --> dash and >~40 --> dot look to to be a good selection level. Finding the delays longer than the (illegible) time between peaks would appear to be all needed for the spaces.
采纳的回答
John D'Errico
2021-11-9
1 个投票
- Use findpeaks to locate each peak. (Ignore the tiny ones. So anything that is significantly above the baseline.)
- The value of the peak will indicate if it is a dash or a dot. high peaks indicate dashes. Low peaks indicate dots.
- Next, check the time between each successive peak. You can almost think of this set of times as a new series. The time between peaks is fairly uniform, except when there is a space. A space is indicated when there is a large chunk of time between successive peaks.
Easy enough. Your job to write the code though.
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Multirate Signal Processing 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
