Hi Jonathan,
It seems that you are trying to find all the places where the bus object is being used. I think you were on the right track to use the “find_system” function for finding the bus objects. You just need to be exhaustive in finding all the references of the object being used by the model.
To begin with finding buses used in a model, please refer to the following MATLAB Answer:
You need to perform a comprehensive search to find all the places where a bus object was being used.
- Load all the necessary models in the library.
- Search for an exhaustive list of block types such as “BusCreator”, “BusSelector”, “Inport”, “Outport”, ”Subsystem”, “Signal Specification” blocks which use bus objects as interface. You also need to check if you are performing signal routing using “From” and “Goto” blocks using bus objects.
- Check if the reference of your desired bus object is being used.
Have a look at the following code snippet:
% Open the example model
model = 'sldemo_bus_arrays';
open_system(model);
load_system(model);
set_param(model, 'SimulationCommand', 'update');
busObjectName = 'sldemo_bus_arrays_busobject';
busUsage = {};
blocks = find_system(model, 'LookUnderMasks', 'all', 'FollowLinks', 'on', ...
'Type', 'block');
% Loop through each block and check relevant parameters
for i = 1:length(blocks)
blockHandle = get_param(blocks{i}, 'Handle');
blockType = get_param(blockHandle, 'BlockType');
% Depending on the block type, check different parameters
switch blockType
case 'BusCreator'
busObject = get_param(blockHandle, 'BusObject');
if strcmp(busObject, busObjectName)
busUsage{end+1} = [get_param(blockHandle, 'Parent'), '/', get_param(blockHandle, 'Name')];
end
case {'Inport', 'Outport'}
portDataType = get_param(blockHandle, 'OutDataTypeStr');
if contains(portDataType, busObjectName)
busUsage{end+1} = [get_param(blockHandle, 'Parent'), '/', get_param(blockHandle, 'Name')];
end
end
end
% Terminate the compilation of the model
set_param(model, 'SimulationCommand', 'stop');
% Close the model if you opened it with load_system
close_system(model, 0);
disp('Bus object usage:');
disp(busUsage);
You can generalize the above snippet to load multiple models and search through each block type. You could also search for the references for the bus object present in the Simulink data dictionary.
I hope this helps!
