Error with the PV array simulation
显示 更早的评论
Hello,
I am currently trying to simulate a single PV cell which I bought from the following link (https://bit.ly/3CmLLeR).
With the PV cell information given in the above link, I built the attached Simulink model to simulate a PV cell's behavior.
However, outputs of current and voltage sensor are a bit strange. I am expecting the voltage range around 0.682 V and current range around 6.24 A, but the sensor ouputs are too huge as shown in the attached pics.
Is there anyone who can help to solve this problem or give me any related information which I can refer?
Thank you very much.
采纳的回答
Joel Van Sickel
2021-11-29
0 个投票
Hello Jung,
you are applying a constantly increasing voltage to the output of the solar cell, so you couldn't get a fixed voltage. You can replace the controlled voltage source with the appropriately sized resistor to see if you get the expected voltage and current. For your numbers I'd guess a resistance of 0.1 would be close to what you are looking for. I would also use scopes instead of displays so you can see the time varying behavior of the model.
Regards,
Joel
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 MATLAB 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
